Wireless On-Board Module 8129

Transmits the data collected by a CarChip Fleet Pro or DriveRight 600E system to a Wireless Base Station. You’ll need one per vehicle. Before installation, complete a few simple steps using our Configuration Cable and Fleet Management Software. Then, plug the module into the CarChip Fleet Pro or DriveRight 600E using the GPS/Wireless Interface Module. Mounts in window of vehicle using the included Velcro® strips or doublesided foam tape.

The Base Station for Wireless Download System connects to a computer running Fleet Management Software 3.7 or later using a USB connection. It communicates with all the Wireless On-Board Modules installed in your fleet and moves the data from the CarChip device to the FMS database. Using FMS, this operation can be performed daily for all the vehicles in your fleet, or only for selected vehicles. You can also initiate a manual download from selected vehicles or your whole fleet.


Product Dimensions:	2.50" x 1.75" x 0.75" (64 mm x 45 mm x 20 mm)
Operating Temperature:	-40°F to +176°F (-40°C to +80°C)
Input Power:	3.3 Vdc
Typical Standby Current:	10mA
Typical Transmit Current:	270mA

Wireless Transmitter Specifications
Frequency:	ISM 2.4GHz
Protocol:	IEEE 805.15.4
Channels:	12
Line of Sight Range:	600' (200 m)
Output Power:	60mW (18dBm) (US); 10mW (10dBm) (Europe)
Receiver Sensitivity:	-100dBM (1% packet error rate)
Agency Certifications:	FCC, IC, CE


Click link to view literature
• Instruction Manual (pdf) This manual provides the instructions necessary to install the DriveRight GPS/ Wireless Interface Module (#8127), GPS Module (#8128), and the Wireless On-Board Module (#8129) with your DriveRight 600 or 600E device.

• Specification Sheet (pdf) The Wireless Download System includes three products, the Wireless On-Board Module (#8129), the Base Station for Wireless Download System (#8130), and the Configuration Cable for Wireless On-Board Module (#8131). These products work together to give your fleet manager the ability to download data directly from the DriveRight or CarChip Fleet Pro to the DriveRight Fleet Management Software (FMS, #8186) database in the fleet office, without any actions by your fleet drivers. With this system, there is no need for the drivers to carry the DriveRight device, CarChip Fleet Pro or SmartCard into the fleet office. The data moves wirelessly from the vehicle to the FMS database.


	CarChip GPS/Wireless Interface	Connects the Wireless On-Board Module to your CarChip Fleet Pro data logger.
	#8251

	DriveRight GPS/Wireless Interface	Connects the Wireless On-Board Module to your DriveRight 600e console.
	#8127

	Wireless Base Station	Receives data from the Wireless On-Board Module and passes it on to the Fleet Management Software. One Base Station per parking lot or office. Larger parking lots may require more than one Base Station.
	#8130

	Configuration Cable	For Wireless On-Board Module. Connects the Wireless On-Board Module to the USB port on your PC for configuration before initial use. One per office or fleet location.
	#8131


Wiring the GPS/Wireless System with a DriveRight 600E The following wiring diagrams display all the possible wiring solutions for connecting the GPS/Wireless Interface Module, GPS Module, and Wireless On-Board Module to an existing DriveRight 600E system.


Wireless Download System Network Set Up The following diagram is of a sample Wireless Download System network.