CarChip Fleet Pro 8246


Installation is easy, just "plug & drive." Plug the tiny data logger into the OBDII port under the dash and begin recording trip details immediately.

• • • •	Engine performance monitoring to keep your vehicles in top running condition. Diagnostic trouble codes, freeze-frame sensor readings, and the ability to clear the vehicle’s check engine light. Emissions readiness reports to check the status of the vehicle’s smog-control systems. Stores up to 1200 hours of driving data depending on the logging interval and number of parameters selected. Download at any time and clear the memory, or simply let the newest data overwrite the oldest. Requires Fleet Management Software, sold separately. To monitor engine performance, use a CarChip Fleet Pro in each vehicle. To monitor driver performance, issue each driver his own CarChip with a unique ID number. Drivers can quickly and easily take their CarChip with them from one vehicle to the next. Requires Fleet Management Software, sold separately.

Includes:

CarChip data logger and USB cable for downloading data

Product Dimensions:

1.80" x 1.00" x 1.32" (46 mm x 26 mm x 34 mm)

Software System Requirements:

Windows 98SE, ME, NT4.0, NT2000, XP, Vista; 5 MB free disk space

Operating Temperature:

-40° to +185°F (-40° to +85°C)

Primary Power, Connected to Vehicle:

-9 to 16 VDC, 80 mA with vehicle running, 17 mA with the vehicle’s power off

Primary Power, Connected to Computer:

USB powered

Backup Power:

Internal battery, minimum of 5 years total, with data logger not powered by vehicle or computer; 10-15 year life in normal use

Memory:

2MB

Data Logging Capacity:

300 hours maximum, depending on logging intervals and number of optional parameters selected

Data Logging Capacity: Data logging capacity is determined by a combination of factors, such as logging intervals, number of optional parameters selected, and, if optional GPS is used, the logging interval used for GPS. Below is a chart of the approximate data logging capacity (in hours) available under various logging interval conditions. Results may vary.

Speed Logging Interval	1-4 Engine Parameters (with Logging Intervals)	Optional GPS (with Logging Intervals)	Hours Stored*
5 seconds	No Parameters Logged	No GPS Logged	1200 hours
5 seconds	No Parameters Logged	15 minutes	1000 hours
5 seconds	4 @ 60 seconds each	1 minutes	520 hours
1 second	4 @ 5 seconds each	15 minutes	90 hours
1 second	4 @ 5 seconds each	1 second	24 hours


Monitor 4 out of 23 possible engine parameters

Parameter	Range*	Resolution*
Vehicle Speed	0 to 158 mph, 0 to 255 km/h, 0 to 70 m/s	0.6 mph, 1 km/h, 0.3 m/s
Trip Distance Traveled	0 to 10.000 miles, 0 to 16,000 km	0.1 mile, 0.1 km
Acceleration/Deceleration/Threshold	0 to 3 G, 0 to 30 m/sec²	0.03 G, 0.3 m/sec²
Engine Speed	0 to 16,384 rpm	1 rpm
Throttle Position	0 to 100%	0.1%
Coolant Temperature	-40° to+ 420°F, -40° to +215°C	2°F. I°C
Engine Load	0 to 100%	0.1%
Air Flow Rate	0 to 8714 lb/min. 0 to 655.36 gm/sec	0.1 lb/min, 0.01 gm/sec
Intake Air Temperature	-40° to +420°F, -40° to +215°C	2°F. 1°C
Intake Manifold Pressure	0 to 75 in. hg., 0 to 255 kPaA	0.3 in. hg., 1 kPaA
Fuel Pressure	0 to 110 psiG, 0 to 765 kPaG	0.5 psiG, 3 kPaG
O2 Sensor Voltage (up to 8 monitored)	0 to 1.275 V	0.005 V
Ignition Timing Advance	-64° to 63.5°	0.5°
Short Term Fuel Trim (up to 2 monitored)	-100% to 99.22%	0.8%
Long Term Fuel Trim (up to 2 monitored)	-100% to 99.22%	0.8%
Battery Voltage	6 to 16 VDC	0.01 VDC
* Range and resolution of sensor measurements only. Accuracy is dependent on the accuracy of the vehicle's sensors.


Click link to view literature
• Instruction Manual (pdf) This manual provides installation instructions for CarChip Fleet Pro (#8246).

• Spec Sheet (pdf) The CarChip Fleet Pro (#8246) logs vehicle trip and engine data to provide a detailed history of driver performance and vehicle operation. The logged data includes trip start and end times, vehicle speeds, rates of acceleration and braking, engine performance data, all detected OBDII trouble codes, and detailed "accident"data for all sudden stops, plus an adjustable audible alarm that can be used to alert drivers of unsafe driving. CarChip Fleet Pro plugs into your car’s OBDII port and is compatible with most passenger cars and light trucks with model years 1996 and later. All CarChip Fleet Pros require DriveRight® Fleet Management Software (FMS) version 3.8 or later, sold separately. Additional CarChip software included with DriveRight FMS allows you to view engine performance data and vehicle trouble codes.


CarChip Fleet Pro mouse over thumbnail for enlargement
	CarChip Fleet Pro
	CarChip Fleet Pro with USB Cable
	CarChip Fleet Pro


	GPS Module	See how and where your vehicles are being driven. Plugs quickly and easily into the CarChip data logger using the appropriate GPS/Wireless Interface Module.
	#8128

	Wireless On-Board Module	Take all the trouble out of downloading driving data to your company PC. With the Wireless Download System, drivers just pull into your parking lot and their data is sent automatically to the PC.
	#8129

	GPS/Wireless Interface Module	Connects the Wireless On-Board Module to your CarChip Fleet Pro data logger.
	#8251

	Fleet Management Software	Our Fleet Management Software lets you track and compare drivers and vehicles by fleet, group, or location. Easy-to-use software lets you sort and summarize data and create reports according to selected criteria.
	#8186